RPM for 0.375" Cast Iron — Cutting Speed
When machining Cast Iron with a 0.375-inch diameter tool, the recommended spindle speed range is 2037–4074 RPM, calculated from a surface speed of 200–400 SFM for carbide tooling. Selecting the correct RPM ensures optimal tool life and surface finish quality. Use this reference alongside your feeds and speeds calculator to set up new operations with confidence.
Recommended Cutting Parameters
| Material | Cast Iron |
| Tool Diameter | 0.375" |
| Recommended SFM Range | 200–400 SFM |
| Recommended RPM Range | 2037–4074 RPM |
Why These Parameters Matter
Running below the minimum SFM causes built-up edge (BUE) and poor surface finish on Cast Iron; exceeding the maximum accelerates tool wear and risks thermal damage to the workpiece and coating. Staying within the 200–400 SFM range for a 0.375-inch tool balances productivity with tool life. These values assume sharp carbide tooling in good condition. Dull tools, poor fixturing, or interrupted cuts may require reducing speed by 20–30% from the recommended range. Depth of cut and radial engagement also influence optimal SFM — lighter finishing passes can tolerate the upper end of the range while full-width roughing passes benefit from the lower end.
Compare Materials — 0.375" Diameter
| Material | RPM (min) | RPM (max) |
|---|---|---|
| Aluminum | 6112 | 10186 |
| Mild Steel | 1528 | 2546 |
| Hardened Steel | 713 | 1222 |
| Stainless Steel | 1019 | 1833 |
| Titanium | 815 | 1630 |
| Cast Iron (current) | 2037 | 4074 |
| Brass | 3056 | 5093 |
| Plastic | 4074 | 8149 |
Machining Tips for This Combination
Cast iron machines dry. Coolant on gray iron creates a slurry of graphite dust and water that wrecks ways, slides, and operators' lungs — use vacuum dust collection at the cutting zone instead. Carbide is the right choice for soft gray iron (Class 25–40), but ductile iron and chilled iron above 280 HB benefit from ceramic or CBN inserts running 2–4× the SFM of carbide. Cast iron is brittle: ramp out of pockets rather than plunging, and beware of the exit edge chipping when the tool breaks through a wall.
Small-diameter tools (under 0.5 inch) live or die by runout. Even 0.002 inch of total indicated runout in a end-mill holder doubles the load on whichever flute happens to engage first and halves tool life. Switch from an ER collet chuck to a shrink-fit or hydraulic holder for production work. Chip load drops to 0.001–0.002 inch per tooth at these sizes, so feed rates are modest and the spindle is asked to turn fast. For hole-making, helical interpolation is gentler than straight plunging — plunging concentrates load on the center of the flute where chip clearance is minimal.
Machining Tips
Use sharp, coated carbide tooling rated for Cast Iron. Apply appropriate coolant: flood coolant for steel and stainless, air blast or MQL for aluminum to prevent chip re-cutting. Verify spindle runout (< 0.0002") before production runs. Reduce feed per tooth by 20–30% for the first pass when breaking surface scale on hot-rolled stock. Always consult your tooling manufacturer's recommended parameters as a primary reference and use these values as a cross-check. Monitor chip color and size during the first cut — blue chips or dust-like chips indicate the speed or feed needs adjustment.