RPM for 0.375" Hardened Steel — Cutting Speed
When machining Hardened Steel with a 0.375-inch diameter tool, the recommended spindle speed range is 713–1222 RPM, calculated from a surface speed of 70–120 SFM for carbide tooling. Selecting the correct RPM ensures optimal tool life and surface finish quality. Use this reference alongside your feeds and speeds calculator to set up new operations with confidence.
Recommended Cutting Parameters
| Material | Hardened Steel |
| Tool Diameter | 0.375" |
| Recommended SFM Range | 70–120 SFM |
| Recommended RPM Range | 713–1222 RPM |
Why These Parameters Matter
Running below the minimum SFM causes built-up edge (BUE) and poor surface finish on Hardened Steel; exceeding the maximum accelerates tool wear and risks thermal damage to the workpiece and coating. Staying within the 70–120 SFM range for a 0.375-inch tool balances productivity with tool life. These values assume sharp carbide tooling in good condition. Dull tools, poor fixturing, or interrupted cuts may require reducing speed by 20–30% from the recommended range. Depth of cut and radial engagement also influence optimal SFM — lighter finishing passes can tolerate the upper end of the range while full-width roughing passes benefit from the lower end.
Compare Materials — 0.375" Diameter
| Material | RPM (min) | RPM (max) |
|---|---|---|
| Aluminum | 6112 | 10186 |
| Mild Steel | 1528 | 2546 |
| Hardened Steel (current) | 713 | 1222 |
| Stainless Steel | 1019 | 1833 |
| Titanium | 815 | 1630 |
| Cast Iron | 2037 | 4074 |
| Brass | 3056 | 5093 |
| Plastic | 4074 | 8149 |
Machining Tips for This Combination
Hardened steel (above 35 HRC, including pre-hardened tool steels, H13, A2, and case-hardened parts) requires a rigid setup and light radial engagement — typically 5–10% of the cutter diameter — with axial depth around 1× diameter to avoid tool deflection. Use high-helix solid carbide with TiAlN or AlTiN coatings rated for the hardness range. Peck-drill any hole more than 3× diameter to clear hot chips and prevent the drill from work-hardening the bottom of the hole, which is the most common failure mode in tool-steel drilling.
Small-diameter tools (under 0.5 inch) live or die by runout. Even 0.002 inch of total indicated runout in a end-mill holder doubles the load on whichever flute happens to engage first and halves tool life. Switch from an ER collet chuck to a shrink-fit or hydraulic holder for production work. Chip load drops to 0.001–0.002 inch per tooth at these sizes, so feed rates are modest and the spindle is asked to turn fast. For hole-making, helical interpolation is gentler than straight plunging — plunging concentrates load on the center of the flute where chip clearance is minimal.
Machining Tips
Use sharp, coated carbide tooling rated for Hardened Steel. Apply appropriate coolant: flood coolant for steel and stainless, air blast or MQL for aluminum to prevent chip re-cutting. Verify spindle runout (< 0.0002") before production runs. Reduce feed per tooth by 20–30% for the first pass when breaking surface scale on hot-rolled stock. Always consult your tooling manufacturer's recommended parameters as a primary reference and use these values as a cross-check. Monitor chip color and size during the first cut — blue chips or dust-like chips indicate the speed or feed needs adjustment.